How to clean your Jura Marble Floor
We recommend the use Marble and Stone Neutral Cleaner.
Marble and Stone Neutral Cleaner cleans and cares in one step. As a neutral cleaner, it is neither acidic nor alkaline, and is perfectly for daily cleaning and maintenance of sensitive materials like Jura marble.
Marble and Stone Neutral Cleaner does not harm the surface or gloss of marble. Regular cleaning using this product helps to refresh the colour Jura marble. Marble and Stone neutral cleaner contains no wax and does not make floors slippery.
1. First vacuum the floor to remove loose dirt.
2. Put 25 ml of Marble and Stone Neutral Cleaner into one bucket (5l) of warm water and mix well.
3. Mop the floor.
4. Rinse the mop frequently in a separate bucket of clean water.
5. Do not rinse the surface, but leave to dry naturally.
How to Polish your Jura Marble
To polish your Jura Marble, we recommends the use of Marble Polish.
Marble Polish gives matte and dull coverings a fresh appearance and also protects new coverings against watery stains and dirt. Regular application of Marble Polish diminishes the signs of use and run marks. Marble Polish makes it easy to polish and creates a brilliant gloss. In addition, slight scratches are evened out.
1. Shake the Marble Polish well before use.
2. Spray thinly and evenly onto the surface, distribute with a clean cloth or sponge.
3. Subsequently polish with a dry, soft cloth.
4. In case of strongly absorbent materials, repeat the procedure.
5. Thorough polishing increases the degree of gloss.
How to Maintain and keep your Jura Marble in good condition
To maintain your Jura Marble, we recommends using Granite and Marble Impregnation once a year or so.
Granite and Marble Impregnation is a ready-to-use special impregnation that protects against oil, grease and water marks. It also helps to block dirt, moisture, paint, oil and grease, and makes cleaning easier. In the event of a spill, any staining liquids can be wiped off easily before they penetrate the surface. Finally, it protects grout against water and oil-based marks.
1. Ensure that the base is clean, dry and absorbent before the treatment.
2. Apply the undiluted product liberally, in an even layer – according to how absorbent the base is – using a soft brush or plastic roller.
3. A second application will make it more effective, but only apply as much as the base can absorb.
4. Let it sit for about 1 hour, then use a dry, absorbent cloth to wipe away any impregnation that did not soak in. Do not leave any streaks.
5. The drying time is 3 to 4 hours; do not step on the treated surface during this time.
6. The impregnation will take full effect after 24 hours